尚雯,杜群贵.单面瓦楞机卡闸机构动力学分析[J].包装工程,2016,37(5):124-129.
SHANG Wen,DU Qun-gui.Dynamic Analysis of the Cassette Mechanism of the Single-sided Corrugating Machine[J].Packaging Engineering,2016,37(5):124-129. |
| 单面瓦楞机卡闸机构动力学分析 |
| Dynamic Analysis of the Cassette Mechanism of the Single-sided Corrugating Machine |
| 投稿时间：2015-09-01 修订日期：2016-03-10 |
| DOI： |
| 中文关键词: 瓦楞机 动力学 建模 振动测试 卡闸机构 |
| 英文关键词: corrugating machine dynamics modeling vibration test cassette mechanism |
| 基金项目:广东省省部级产学研 （2012B091000140）；广东省省级科技计划 （2013B010203016） |
|
| 摘要点击次数: |
| 全文下载次数: |
| 中文摘要: |
| 目的 分析单面瓦楞机卡闸机构振动产生的原因并对其进行减振优化。方法 对单面瓦楞机的关键机构卡闸机构进行了动力学建模， 上下瓦楞辊是变中心距啮合， 然后在Ansys中作上下瓦楞辊的模态分析， 并对单面瓦楞机进行了振动测试。结果 将测试的结果与建立的数学模型、 模态分析得到的固有频率对比， 得到单面瓦楞机振动的根本原因是在频率为154， 217 Hz等处发生共振， 最后对卡闸机构进行减振优化， 达到了减振效果。结论 文中建立的动力学模型和仿真对研究单面瓦楞机振动特性的研究是有效的。 |
| 英文摘要: |
| The aim of this article was to analyze the causes for vibration of the cassette mechanism of the single-sided corrugating machine and the vibration reduction optimization was conducted. The dynamics model of the key cassette mechanism of the single-sided corrugating machine was established. The mesh center distance of the upper and lower corrugating roll was changing. Then the simulation of the modal analysis of the upper corrugating roll and lower corrugating roll was conducted in Ansys, and then a vibration test was conducted on the single-sided corrugating machine. Comparing the test results with the natural frequency obtained from the roller′ s modal analysis and the dynamic model established for the cassette mechanism, the primary reason of single-sided corrugating machine′ s vibration was found to be the resonance occurring at the frequency 154, 217 Hz, etc. Finally, the vibration reduction optimization of the cassette mechanism was conducted. All the above proved the effectiveness of studying the vibration characteristics of single-sided corrugating machine using the established dynamic model and simulation of Ansys. |
|
查看全文
查看/发表评论 下载PDF阅读器 |
| 关闭 |
渝公网安备 50010702501716号