文章摘要
陈满儒,张惠艳.CPS理念下灯具包装设计方法研究[J].包装工程,2014,35(23):43-46,99.
CHEN Man-ru,ZHANG Hui-yan.Packaging Design Method of Lamps & Lanterns via CPS Concept[J].Packaging Engineering,2014,35(23):43-46,99.
CPS理念下灯具包装设计方法研究
Packaging Design Method of Lamps & Lanterns via CPS Concept
投稿时间:2014-09-21  修订日期:2014-12-10
DOI:
中文关键词: CPS理念  灯具  包装设计  有限元分析  TOPS Pro软件
英文关键词: CPS concept  lamps & lanterns  packaging design  finite element analysis  TOPS Pro software
基金项目:
作者单位
陈满儒 陕西科技大学西安 710021 
张惠艳 陕西科技大学西安 710021 
摘要点击次数:
全文下载次数:
中文摘要:
      目的 通过对灯具市场的调研分析, 提出一种基于CPS理念的灯具包装方法。方法 以装饰性台灯为例, 将其计算机模型作为研究对象, 并以有限元分析软件Ansys为平台, 通过静态和动态性能的研究, 得出包装件的应力应变情况。最后利用TOPS Pro软件的优化功能进行装箱优化。结果 从有限元分析数据可以看出, 最大应力与固有频率都满足包装要求。装箱优化后, 卡车的面积使用率为95.7%, 体积使用率为88.6%。结论 通过设计与研究, 得到了一种既合理又低成本的包装方法。
英文摘要:
      Objective To propose a packaging method for lighting fittings based on the CPS concept following the marketing survey. Methods Taking the geometrical model of lamp as a study object, the stress and strain were achieved through finite element static and dynamic analyses with ansys as a platform. Finally, an optimal packaging alternative of lamp fittings was presented with TOPS Pro. Results It was found from the finite element analysis data that the maximum stress and natural frequency both met the packaging requirements. After optimization, the area and cube utilization rates of truck were 95.7% and 88.6%, respectively. Conclusion Through the design and study, a package method which was both reasonable and of low cost was obtained.
查看全文   查看/发表评论  下载PDF阅读器
关闭

关于我们 | 联系我们 | 投诉建议 | 隐私保护 | 用户协议

您是第20799106位访问者    渝ICP备15012534号-2

版权所有:《包装工程》编辑部 2014 All Rights Reserved

邮编:400039 电话:023-68795652 Email: designartj@126.com

    

渝公网安备 50010702501716号