文章摘要
沈 斌,傅燕鸣,吴 宵,郭 娟.胶印机滚筒结构的拓扑及尺寸优化设计[J].包装工程,2012,33(21):24-26,44.
SHEN Bin,FU Yan-ming,WU Xiao,GUO Juan.Topology and Sizing Optimization for Structure Design of Printing Cylinder[J].Packaging Engineering,2012,33(21):24-26,44.
胶印机滚筒结构的拓扑及尺寸优化设计
Topology and Sizing Optimization for Structure Design of Printing Cylinder
投稿时间:2012-08-08  修订日期:2012-11-10
DOI:
中文关键词: 胶印滚筒  拓扑优化  尺寸优化  结构优化
英文关键词: printing cylinder  topology optimization  size optimization  structure optimization
基金项目:
作者单位
沈 斌 上海大学, 上海 200072 
傅燕鸣 上海大学, 上海 200072 
吴 宵 上海大学, 上海 200072 
郭 娟 上海大学, 上海 200072 
摘要点击次数:
全文下载次数:
中文摘要:
      胶印机滚筒在印刷压力作用下的挠曲变形是影响印品质量的重要原因。 以 PZ1740 胶印机橡皮滚筒为研究对象,提出了一种基于拓扑优化和尺寸优化的橡皮滚筒结构设计方法。 建立了滚筒结构的二维拓扑模型,以应变能最小为目标,体积分数作为约束,得到滚筒结构的拓扑分布;在拓扑构型基础上,建立了滚筒结构的参数化模型,以挠曲变形最小为目标,结构质量作为约束条件进行尺寸优化,得到了滚筒具体的结构。 优化分析结果表明,优化后的滚筒结构在质量约束的条件下有效地减小了挠曲变形,提出的方法在胶印机滚筒结构优化设计中可行且有效。
英文摘要:
      The flexural deformation of printing cylinder under the printing pressure is an important factor influencing printing quality. Structural design method of printing cylinder based on topology optimization and size optimization was put forward with an example of PZ1740 blanket cylinder. In topology optimization, two-dimensional topological model was established; the topology distribution was obtained with minimizing compliance as objective and volume fraction as constraint. Parametric model of printing cylinder was built for size optimization; detailed structure of printing cylinder was obtained using minimizing flexural displacement objective and mass as constraint. The optimization results showed that printing cylinder structure can effectively reduce flexural displacement under constraint mass; the proposed method is feasible and effective for optimal design of offset printing cylinder.
查看全文   查看/发表评论  下载PDF阅读器
关闭

关于我们 | 联系我们 | 投诉建议 | 隐私保护 | 用户协议

您是第20794280位访问者    渝ICP备15012534号-2

版权所有:《包装工程》编辑部 2014 All Rights Reserved

邮编:400039 电话:023-68795652 Email: designartj@126.com

    

渝公网安备 50010702501716号